Your HVAC Maintenance Checklist: What Should You Do Each Season?

Your HVAC maintenance checklist isn’t one-size-fits-all. In Southeast Missouri, where summers push past 90 degrees and winters can dip below zero, your system carries more of a load than most. Many local homes run older equipment, and a little seasonal attention goes a long way toward keeping everything humming. Here’s what to do, when to do it, and when to hand the job to a licensed tech.

Why Staying Ahead of the Seasons Makes a Difference

Our climate swings hard between extremes, and those swings take a real toll on your equipment. Seasonal HVAC maintenance gets your system ready for each major temperature shift. Consistent air conditioner and furnace upkeep means fewer surprise failures, lower monthly energy costs, and more years of life from your investment.

What You Can Tackle on Your Own

Good homeowner HVAC care starts with a few reliable habits. Most of these take only minutes and require little more than a stepladder or a pair of gloves:

  • Change the air filter. Swap it every 30 to 90 days. During heavy-use months, check it every 30 days.
  • Clear the outdoor unit. Keep grass, leaves, and shrubs at least two feet back from the condenser.
  • Keep vents unblocked. Shift furniture and rugs away from supply and return grilles.
  • Update the thermostat. Fresh batteries once a year and a seasonal settings review go a long way.
  • Test your CO detectors. Replace batteries annually and retire units past their expiration date.

These steps let air move freely, reducing strain on your system. Beyond that, leave gas lines, wiring, and refrigerant to the professionals.

When to Pick Up the Phone

Certain jobs demand proper training, calibrated tools, and valid credentials. Missouri requires a licensed mechanical contractor for HVAC work. Refrigerant handling also calls for EPA Section 608 certification. These requirements protect both your household and the people working in it.

A professional visit covers far more ground than routine maintenance. Our techs measure refrigerant charge, stress-test capacitors and motors, examine the heat exchanger, and verify gas pressure. We scan for carbon monoxide and confirm every safety switch is functioning. Two professional visits per year are the standard, but call sooner if you catch strange sounds, unusual odors, or a spike in your energy bill.

A Season-by-Season Breakdown

Now that you know who handles what, it’s time to put it on the calendar. This HVAC maintenance schedule is built around the weather patterns we actually see across the region.

  1. Spring: Book a Pre-Summer AC Check

Line up your cooling maintenance before the first 90-degree day hits. Your tech will clean the coils, check refrigerant levels, and inspect the electrical components. Catching a struggling system in April beats scrambling for emergency service in July.

  1. Spring: Tidy Up Around the Outdoor Unit

Spring storms drop plenty of branches and yard debris. Walk around your condenser each spring and after any significant storm. Clearing that space keeps airflow strong, which helps your AC work faster and use less electricity.

  1. Summer: Step Up Filter Changes

Extended run times pull more dust and debris through your system. During peak cooling season, pull the filter every 30 days and swap it out when it starts looking dark gray. A fresh filter shields your blower motor and keeps the air in your home cleaner.

  1. Summer: Pay Attention to Warning Signs

Sustained summer heat wears down compressors, capacitors, and motors faster than any other season. Tepid air from the vents, frost forming on refrigerant lines, or a persistent buzzing sound are all reasons to call us without delay. Catching a problem early almost always costs less than waiting.

  1. Fall: Get the Furnace Checked

Fall is the right window to evaluate your heating system before you actually need it. After sitting dormant all summer, furnaces sometimes refuse to light or, in more serious cases, produce carbon monoxide. A pre-winter inspection removes that uncertainty and keeps your household protected.

  1. Fall: Swap Out CO Detector Batteries

Your furnace will run for long stretches once temperatures drop. Put fresh batteries in every detector each fall and confirm coverage on all levels of your home, with extra attention near sleeping areas and fuel-burning appliances.

  1. Winter: Watch Your Heat Pump Closely

Heat pumps shed efficiency once outdoor temps fall below 30 degrees. If yours runs nonstop or produces only lukewarm air, reach out. We’ll evaluate the backup heat source and make sure your household stays comfortable through even the sharpest cold snaps.

  1. Winter: Keep the Outdoor Unit Clear

Heavy snow and ice can obstruct your outdoor unit and block exhaust vents. After each storm, brush snow off by hand and check that vents are open. Avoid chipping ice off the coils directly; that can bend or break the fins.

smiling-hvac-technician-in-navy-uniform-and-branded-hat-leaning-on-a-large-white-exterior-hvac-condenser-unit

Year-Round Comfort, Backed by Local Know-How

A consistent seasonal approach protects your household’s comfort, your monthly budget, and your family’s well-being. At Nicholson Heating & Air, our licensed crew understands how Southeast Missouri’s climate affects residential HVAC equipment, whether that’s an aging furnace in a historic in-town house or a newer heat pump out on a rural property.

We walk you through every finding in plain language and never recommend work that isn’t warranted. Browse our maintenance, repair, and replacement options to find what fits your home and your schedule.

FREQUENTLY ASKED QUESTIONS

Plan on two visits a year. Nicholson Heating & Air recommends a spring AC tune-up and a fall furnace inspection to keep your system dialed in for each season.

Most filters need replacing every 30 to 90 days. Check monthly during peak summer and winter use, and go sooner if you have pets or anyone in the home with allergies.

No. Missouri requires EPA Section 608 certification to handle refrigerant. Low refrigerant is also a symptom of a leak, a problem a certified technician needs to locate and repair properly.

Furnaces that sit idle through the summer can fail to light or develop carbon monoxide issues. A fall visit from Nicholson Heating & Air surfaces those problems before the cold sets in.

Most systems last about 10 to 15 years. Hot, humid summers and hard freezes accelerate wear, so consistent upkeep helps your equipment reach its full service life.